Kia K5 Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
132 Posts
Discussion Starter · #4 ·
Well splitter and side skirts installed. Looked at the rear diffuser and too much modification needed for proper fit for someone like me who is not good was that kinds of adjustments. One of our mechanics at work should be able to help for a case of beer or something on a weekend.

Pictures of the final product below.

Was pretty easy to install. fit well without much adjustments, a couple of simple push or pull 1/2 inch or so to get to the right spot at the ends. Took less than 2 hours from pulling into garage until backing out (including clean up.

Tools needed: screw gun with Philips head and proper sized drill bit for the bolts (had to drill 6 holes for the splitter install, flat tip screw driver, socket wrench with 10 MM socket, and 10 mm open end wrench.
Land vehicle Car Vehicle Grille Automotive tire
Automotive parking light Grille Automotive lighting Automotive tire Hood
Automotive parking light Automotive tail & brake light Vehicle Hood Automotive tire

One more thing, installing the splitter works much easier if you disconnect the cover on the bottom of the car, much easier to get the bolts and nuts in. (3 bolts and about 8 of round plastic connectors to loosen up the front of the cover to get your hands to where they need to be to install the bolts.
 

·
Registered
Joined
·
132 Posts
Discussion Starter · #8 ·
ADRO


Going to get the rear spoiler next month.

Wish I could find some for the interior especially to cover up the shiny black parts.
 
1 - 8 of 8 Posts
Top